Cookie Consent

Cookies are used for statistical purposes and to improve the site.
Cookies will be used after you click "Accept" or if you continue using Dynisco.com
To find out more please review our Privacy Policy.

Accept

EMT4632

The intrinsically safe melt pressure transducer series EMT based on the proven melt pressure transmitter series MDT. The integrated, PTB-approved, 2-wire mAmp amplifier converts the process pressure into an proportional output signal. The 2-wire mAmp amplifier technique is insensitive to noise and well suited for economical long cable runs. The EMT-series 432/463 features an integral thermocouple that allows pressure and temperature to be measured in a single sensor.
Many of the features found in Dyniscos standard MDT-series have been incorporated into the EMT-series, including proven bonded strain gauge construction for stable operation, a flexible armored capillary between the amplifier housing and the rigid stem and a flush diaphragm. Another advantage is the electrical built-in calibration.

⚠ WARNING: This product can expose you to chemicals including mercury and lead, which is known to the State of California to cause cancer and reproductive harm. For more information, go to www.P65Warnings.ca.gov.

  • Intrinsically safe according EX-safety class EEx ia IIC T5 up to 80°C
  • Intrinsically safe according EX-safety class EEx ia IIC T1-T4 up to 85°C
  • Installation for media temperature up to 400°C
  • Flexible capillary between rigid stem and housing
  • Electrical built-in calibration
  • Integral thermocouple for simultaneous temperature measurement at the media

Have A Question? Ask a Dynisco expert for more information.

  • Dynisco

    38 Forge Parkway,
    Franklin MA 02038

    +1 508 541 9400  

  • Dynisco Europe GmbH

    Pfaffenstr. 21, 74078,
    Heilbronn, Germany

    +49 7131 297 0

  • Dynisco-Viatran Instrument Sdn Bhd

    Lot 3615, Jalan SM 6/8
    32040 Seri Manjung, Perak, Malaysia     

    +605 6884014