Cookie Consent

Cookies are used for statistical purposes and to improve the site.
Cookies will be used after you click "Accept" or if you continue using
To find out more please review our Privacy Policy.



The PT449 transducer is a miniature pressure transducer that mounts directly in the mold, flush with the cavity surface. The transducer does not depend upon knockout pins, thus eliminating pin hangup and improving measurement accuracy. The PT449 is used to measure peak cavity pressure, the most accurate and repeatable way to initiate the holding pressure phase.

  • Mounts flush with cavity
  • Sensing tip can be shaped down 0.05
  • Direct contact with material
  • Withstands 400°F mold and 600°F melt temperatures
  • 6 mm sensing area (4 mm available)
  • Standard 80% shunt calibration

Have A Question? Ask a Dynisco expert for more information.

  • Dynisco

    38 Forge Parkway,
    Franklin MA 02038

    +1 508 541 9400  

  • Dynisco Europe GmbH

    Pfaffenstr. 21, 74078,
    Heilbronn, Germany

    +49 7131 297 0

  • Dynisco-Viatran Instrument Sdn Bhd

    Lot 3615, Jalan SM 6/8
    32040 Seri Manjung, Perak, Malaysia     

    +605 6884014